Fixed Instrument Stringer | Rigid Stainless Steel Wire Frame for Ring-Handled Instruments | CSSD Grade

Closed At One End. Open At The Other. Rigid All The Way Through.

The Fixed Instrument Stringer is the rigid one: a single continuous stainless wire formed into two long parallel runs, squared off at one end through two rounded right-angle corners and left open at the other. There is no joint anywhere in the frame, and that is the point — the two runs hold their spacing under load, so a set stays exactly where it was threaded instead of drifting as the frame is moved from station to station. Ring-handled instruments slide on through the open end and come to rest against the flat cross bar at that end, so the set spreads along the frame with each instrument held open and clear of the next one: box joints, ratchets and hinges are left exposed to the medium rather than clamped shut against a neighbouring instrument. The frame carries the whole set through the cycle and out again as one bundle, so no instrument is picked up on its own. Where this version differs from the foldable stringer is simply that it does not fold — there is nothing to open, close or hold straight, and the frame is ready to load every time it is picked up.

Nothing To Fold Or Straighten
One rigid frame, ready to load every time it is picked up.
Runs Held At Spacing
With no joint in the frame, the runs keep their spacing under load.
Set Stays As Threaded
Instruments stay where they were positioned instead of drifting along the frame.
Squared-Off Closed End
Two rounded right-angle corners form the rigid end of the frame.
Open End For Loading
The set slides on and off through the open end as a group.
A Stop To Park Against
A flat bar across the lower run parks the set at the open end.
Instruments Held Open
Each instrument hangs clear, so joints and ratchets stay exposed.
Lifts Out As One Bundle
A stringed set is handled as a unit rather than instrument by instrument.

Applications: